Genie Excelerator Owner's Manual - Page 22

ACCESSORIES Installation SteCpH11: PROGRAMMING THE REMOTE CONTROL A To program one Button of a Remote Control (Figure 37): • Locate Learn Button and Learn Indicator Light near Terminal Block on Power Head (Figure 38). • Press and release Learn Button. Red Learn Indicator Light will blink 2 times per second. • Press Remote Control Button once within 30 seconds. Red Learn Indicator Light will stay lit. • Press Remote Control Button again. Red Learn Indicator Light will go out, indicating that memory is stored. B Program each additional Remote using step A above. To Erase All Remotes from Power Head Memory A Press and hold Learn Button on Power Head for 10 seconds or until Learn Indicator Light goes out. Memory is erased: • Program Remotes again as needed. NOTE • Each Remote Control must be programmed separately. • The Remote Controls will not cause the door Opener to close the garage door if the Safe-TBeam® System is malfunctioning. • When programming the Remote Controls, they must be at least 24" from the Antenna Wire. • If the red Learn Indicator Light blinks approximately 4 times per second, programming has stopped. If programming has stopped, repeat the above steps. • Each Button on a 2 or 3 Button Remote Control is for a different Opener. You cannot use more than one Button per Remote, per Opener. • A maximum of seven Remote Controls or Wireless Keypads can be stored into the Receiver at one time. If a Remote Control becomes lost, or if you want to delete a Remote Control or Wireless Keypad, see "To Erase All Receiver Memory." To Replace Remote Control Battery A Push in on Battery Cover Latch at base of Remote Control (Figure 39): • Use coin, pen, screwdriver or any similar device. - Cover snaps open. • Replace old Battery with new A23, 12 Volt Battery. B Snap Battery Cover closed. WARNING A moving garage door may cause serious injury or death. • Keep people clear of opening while door is moving. • Do not allow children to play with the Remote Controls. If the Safety Reverse does not work properly: • Close the door and disconnect the Opener using the Emergency Release Cord. • Do not use the door Opener, Remote Controls, or Wireless Keypad. • Refer to the door and door Opener Owner's Manuals before attempting any repairs. Remote Control Operation A Press Button on Remote Control. Garage door will move. B Press Button again. Garage door will stop: • The door automatically stops at the end of the open or close cycle. C Press Button again. Garage door will reverse. 1 Button Remote 48 2 Button Remote 51 3 Button Remote 49 Figure 37 Genie Remote Controls Learn Code Button STATUS LEARN LEARN INDICATOR LIGHT Figure 38 Learn Code Button and Indicator Light Model Number Visor Clip Push to open Battery Cover Figure 39 Remote Control Battery Replacement 22 For Help, call 1-800-35-GENIE or visit www.geniecompany.com