Genie Excelerator Owner's Manual - Page 23
Installation Step 12 - programming keypad
View all Genie Excelerator manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Installation Step 12: OPERATING WIRELESS KEYPAD WARNING A Moving door can cause serious injury or death. 1 Keep people clear of opening while door is moving. 2 Do Not allow children to play with Wireless Keypad. 3 During programming, the door opener could begin to run, so stay away from the moving door and its parts. To keep the door from moving, close the door and disconnect it from the Opener by pulling the Emergency Release. If Safety Reverse does not work properly 1 Close door and disconnect the Opener using Emergency Release Cord. 2 Do not use door Opener, Remote Controls, or Wireless Keypad. 3 Refer to Door and Door Opener Owner's Manuals before attempting any repairs. NOTE FOR CONVENIENCE - Program Keypad BEFORE mounting. Programming for 1 Door Opener A Set Wireless Keypad PIN (Personal ID Number): • Activate programming mode. - Press (in order) . - Red LED blinks - once per second. • Enter your PIN (3 to 8 characters). • Press . - Red LED blinks - twice per second and turns off. B Programming One Door Operator: Figure 1 • Find the Learn Code Button and Learn Code Indicator LED on your door opener. - If your door opener has a black antenna Indicator LED wire,the Learn Code Button and Indicator LED are located near the antenna. (The light lens may need to be opened) - If your door opener does not have an antenna,you have an external receiver. The external receiver cover must be Located on Opener Housing removed to access the Learn Code Button and Indicator LED. • Press the Learn Code Button. - Learn Code Indicator LED (on Opener) Learn Code Button will blink. • Enter your PIN and press . - Learn Code Indicator LED stays on. • Press again. - Learn Code Indicator LED turns off. C Operating One Door Operator: • To move the garage door: - Enter your PIN. - Press . NOTE • If the door does not move,check the red LED on Keypad. If the LED is blinking rapidly,the PIN was entered incorrectly. After the LED stops blinking, re-enter your PIN and try again. • Any keypad button will control the door for 30 seconds after the door starts moving. • Rapid Blinking of the red LED indicates an error. After a few seconds the LED will turn off. Start over. Proceed to "Mounting Wireless Keypad." Programming for 2 or 3 Door Openers A Set Wireless Keypad PIN (Personal ID Number): • Activate programming mode. - Press (in order) . - Red LED blinks - once per second. • Enter your PIN (3 to 8 characters). • Press . - Red LED blinks - twice per second and turns off. B Programming the Keypad for Multiple Door openers: All door openers will use the same PIN. • Enter your PIN and press . - Red LED blinks - once per second. • Press again. - Red LED blinks - twice per second. • Press the number of doors (total) you wish to control ( or ). • Press . - Red LED blinks several times and turns off. C Programming Door Openers: • Decide which door will be door #1,#2 and #3. • Press the Learn Code Button (see Figure 1). - Learn Code Indicator LED (on Opener) blinks. • Enter your PIN and press . - Learn Code Indicator LED stays on. • Press the number you have picked for this door Opener ( or or ). - Learn Code Indicator LED stays on. • Press . - Learn Code Indicator LED turns off. B Repeat step A above for each door opener. Each door opener must be programmed to receive the signal from the Wireless Keypad. (continued on next page) For Help, call 1-800-35-GENIE or visit www.geniecompany.com 23