Genie Excelerator Owner's Manual - Page 24

Programming for 2 or 3 Door Openers (Continued) A Operating 2 or 3 Door Openers: • To move one of the doors. • Enter your PIN. • Press . • Press door opener number ( or or ). SEE NOTE AT TOP OF PREVIOUS COLUMN MOUNTING INSTRUCTIONS The Keypad must be mounted in sight of the door(s), at least 5 feet above the ground and clear of any moving door parts. A Mount Keypad.(Mounting screws located inside battery compartment.) • Remove Battery Cover. See Figure 3. • Drill a 1/16"pilot hole for the top mounting screw. • Install a screw into the drilled hole, leaving a 1/8" gap between the screw head and the wall. See Figure 2. • Hook the Keypad over the screw. • Mark,drill pilot hole and fasten bottom screw. • Reinstall Battery Cover. Figure 2 1" 8 Wall screw head gap BATTERY CHANGES. If the red LED does NOT blink during use,the battery needs to be changed. Figure 3 Red LED PROG DEF 123 GHI JKL MNO 456 PQRS TUV WXYZ 789 0 99V BBaatttery Press here Bottom Mounting Screw USING A TEMPORARY PIN. A temporary PIN allows temporary access to your home by repair persons, meter readers, etc. A Enter your PIN • Press . B Enter the Temporary PIN (from 3 to 8 characters). • Press . NOTE • DO NOT reprogram the Door Opener(s). • Temporary PIN remains active until the next time your normal PIN is entered. BASIC ADDITIONAL INSTRUCTIONS FORGOT YOUR PIN OR CHANGING YOUR PIN. A Erase old PIN : • Press and hold in order . - Red LED will blink once and turn off. • Release all buttons. B Programming Door Opener(s). • Return to"Programming for 1 Door Opener"or "Programming for 2 or 3 Door Openers." 24 For Help, call 1-800-35-GENIE or visit www.geniecompany.com