Genie Excelerator Owner's Manual - Page 26
Warning, To Reduce The Risk Of Severe Injury Or Death - garage door opener problems
View all Genie Excelerator manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
IMPORTANT SAFETY INSTRUCTIONS WARNING TO REDUCE THE RISK OF SEVERE INJURY OR DEATH 1 READ AND FOLLOW ALL INSTRUCTIONS. 2 Never let children operate or play with the Door Controls. Keep the Remote Control away from children. 3 Always keep the moving door in sight and away from people and objects until the door is completely closed. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR. 4 NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR. 5 Test Opener monthly. The door MUST reverse on contact with a 1-1/2" high object (or a 2" x 4" board laid flat) at the center of the doorway on the floor. After adjusting either the Force or the Limit of travel, retest the Door Opener. Failure to adjust the Opener properly may cause severe injury or death. 6 When possible use the Emergency Release only when the door is closed. Use caution when using this Release with the door open. Weak or broken springs are capable of increasing the rate of door closure and increasing the risk of severe injury or death. 7 KEEP GARAGE DOORS PROPERLY BALANCED. See Owner's Manual. An improperly balanced door increases the risk of severe injury or death. Have a Genie Factory Authorized Dealer make repairs to cables, spring assemblies, and other hardware. 8 SAVE THESE INSTRUCTIONS. WARNING Use the Wall Console included with Opener. Any other wall console can cause the Opener to operate unexpectedly and the light to stop working. TROUBLESHOOTING GUIDE Safe-T-Beam® System Self-Diagnostic Troubleshooting Source (Red LED) ON OFF OFF 2 BLINKS, Pause (Repeat) 2 BLINKS, Pause (Repeat) 3 BLINKS, Pause (Repeat) 4 BLINKS, Pause (Repeat) Sensor (Green LED) ON OFF ON ON OFF ON ON Possible Problem Normal operation • Power Head not powered • Wiring from Power Head bad Solution None required • Check breakers, fuses, plugs • Check wiring for obvious shorts • Wiring to Source missing or bad • Power has been interrupted • Beam not aligned • Beam obstructed • Sensor defective • Wire to Sensor missing or bad • Sensor defective • Sensor receiving interference • Source not sending pulses • Source defective • Check wiring • Remove power and reapply • Check Source, Sensor alignment • Check for obstruction • Contact Customer Service • Check wiring • Contact Customer Service • Determine source of interference • Contact Customer Service • Contact Customer Service • Contact Customer Service 26 For Help, call 1-800-35-GENIE or visit www.geniecompany.com