Hamilton Beach HBS1200 Operation Manual - Page 15

Caring for the Ice Shaver/Blender Maintenance Inspect the blender and its various parts and replace as follows: Daily Weekly Quarterly Unplug the unit and remove the container from the base, and then inspect the container and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if necessary. If the blades are loose, discontinue use immediately and replace the blades. See "Replacement Parts" below. Unplug the unit, and then inspect the power cord insulation and power plug for cracks. Refer to "Requesting Assistance or Service" for repair or replacement. Replace the container and cutter assembly at least every 90 days. See "Replacement Parts" below. Replacement Parts Refer to "Technical Service" to order parts below. Part Description 64 oz. container Cutter assembly Ice shaver blade assembly Shaver belt Blender belt Blender motor brush kit Blender motor assembly Chute cover/splash shield Inner ice hopper Ice hopper cover Jar pad Drive bearing assembly with clutch Pre-programmed memory card Container lid with filler cap Drain hose Controls panel Agititator/thumbscrew/O-ring Shaving pool with chute Hopper isolation grommets Main PCBA assembly Speed/revolution sensor Leveling foot/jam nut Belt tensioner assembly Inner hopper/Hopper lid interlock switch Part Number 6126-1200 961200 SB1200 990028700 990028800 990028900 990029000 990029100 990029200 990029400 990029500 990029600 MC1200 990029800 990029900 990030000 990030200 990030300 990030400 990030500 990030600 990030700 990030800 990030900 15