Hamilton Beach HBS1200 Operation Manual - Page 7

Operation Start-Up Messages Start Up Messages Once the unit has been set-up in the desired location move the main power switch to the ON (I) position. The following message should appear in the display: LOADING SETTINGS Once initial settings have loaded, the display will show the following standby message: 8OZ 12OZ 16OZ 20OZ HAMILTON BEACH COMMERCIAL 1DR 2DR 3DR 4DR NOTE: If the memory card has not been installed, or is not properly installed, the following messages will appear: TURN OFF MAIN POWER SWITCH AND INSERT MEMORY CARD If this message appears, turn the unit off, unplug it, and make sure that the memory card is properly installed. Then plug the unit back on and restart it. Diagnostic Messages Diagnostic Messages The ice shaver/blender control system has a number of safety and diagnostic features. Some of these features are monitored by sensors, such as the jar pad sensors, drain sensor, and safety interlocks on the ice hopper. INNER HOPPER NOT IN PLACE Cycle Counts When the unit is in standby mode, pressing the L and M buttons will scroll through status and diagnostic messages. These include the current cycle count and the number of cycles remaining in the warranty. Service Messages Others, such as service messages, are based on operating cycle count, and are designed to let you know when parts subject to wear should be replaced. The lifespan of these parts is based on number of cycles under normal operating conditions. Pressing the STOP button will allow the unit to run 100 cycles before the message reappears. Once service has been performed, press PULSE to set the cycle count back to zero for that service item. SERVICE MESSAGE REPLACE CUTTER ASSEMBLY TOTAL SHAVE/BLEND CYCLES - 999999 CYCLES REMAINING IN WARRANTY - 999999 7