Harman Kardon AVR85 Owners Manual - Page 19
Clearing the Remote Memory
View all Harman Kardon AVR85 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Remote Control Programming and Operation 16 All other keys may only be programmed with one remote code. The code contained in these keys remains the same regardless of the source selection. WARNING: These keys transmit codes that are vital to the operation of the product. It is not recommended that they be programmed with alternative codes, as it may then be impossible to operate certain functions of the receiver. Night Delay RF Opt Coax Select All Navigation Buttons All Mode Selectors * # Display OSD Speaker ⁄¤ CH Select Volume ⁄¤ Test Tone Mute To program the remote, follow these steps. Note that it is not necessary to program all keys, only those that are required to operate the subject device. Keys not programmed will retain the codes preprogrammed at the factory. 1. Slide Use/Learn a switch at the top left corner of the remote to the right so that it is next to Learn. 2. If one of the multifunction buttons is being programmed press the source button (i.e. CD, VID1, etc.) you wish to have this function associated with. If you are programming a single function key, proceed to the next step. 3. Press the button on the remote that is to be programmed. Note that the Learning ` LED will illuminate. 4. Place the remote head to head with the remote control whose function is being learned. The two remotes should be no more than 8 inches apart. 5. Press and hold the button on the remote corresponding to the function to be memorized until the Learning LED starts to blink. When the LED goes out, release the button on the transmitting remote. The function code has been successfully captured by the remote. NOTE: If both LEDs flash during a programming operation, it indicates that the remote's memory is full or that the remote codes from the transmitting remote are not compatible with the unit's signal format. 6. Continue to program any additional remote commands required using steps 2 through 5. When you have finished programming the remote, slide the Use/Learn switch to the left so that it is in the Use position. Clearing the Remote Memory In normal operation, codes for a new device may be programmed "over" the codes that have been previously programmed into the remote. It is also possible to clear the memory for individual keys, or for the entire remote. When a memory position is cleared, the remote will return to the original factory preset command. To clear the memory for a specific individual key location, put the Use/Learn switch in the Learn position. Press the Main Power Off c button and the button to be cleared at the same time. Both the Sending and Learning indicators will light momentarily. When the lights go out, the memory has been cleared of the user programmed code and returned to the factory preset. Return the Use/Learn a switch to the Use position when you are finished. To clear the remote's entire memory and return all keys to their factory preset commands first put the Use/Learn a switch in the Learn position. Then press the Main Power On button c and confirm that the Learning indicator ` has illuminated. While continuing to press the Power On button, press and hold the Power Off c button until the Learn indicator goes off for about 3 seconds. It will then blink twice. Then release the two buttons. This indicates that the memory has been cleared of any user programmed commands and that the original commands have been restored. Slide the Use/Learn switch a back to the Use position to return the remote to normal operation.