Hayward Ecommand W/2Gva/Base/Aquaconne ECOMMAND-4-Installation-Manual-092419AR - Page 15
Temperature Sensors, Base Station
View all Hayward Ecommand W/2Gva/Base/Aquaconne manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Temperature Sensors The ECOMMAND 4 utilizes 10K ohm thermistor type sensors. Three sensors (water temperature, air temperature and solar temperature) are included. If the ECOMMAND 4 is being used to control a solar heating system, the solar sensor is required. The sensors are provided with a 15 ft. cable. If a longer cable is required, contact the Hayward service dept. for information on suitable cable types and splices. See page 3 and the diagram below for installation information. POOL/SPA SENSOR AIR SENSOR SOLAR/SPA SENSOR Pool/Spa Air Solar Base Station Plug in the pigtail connector from the wireless base station into the "wireless" connector on the main PCB in the ECOMMAND 4 control unit. AQL2-BASE-RF Base Receiver Connector for Base Receiver Main PCB Tighten nut 14 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS