Hayward Ecommand W/2Gva/Base/Aquaconne ECOMMAND-4-Installation-Manual-092419AR - Page 3

Introduction What's Included Before attempting to install the ECOMMAND 4 system, check that the following components have been included in the package: ECOMMAND 4 Electronics Unit (3) Temperature sensors with 15 ft. (5m) cable, hose clamp (2) Hayward GVA-24 actuators (HPC-4-ACT, HPC-4-ACT-RC only) (1) Hayward AQL2-BASE-RF/AQL2-SS-RF remote control (HPC-4-RC, HPC-4-ACT-RC only) What's NOT Included Some of the additional items that you may need to complete an installation include: Circuit breakers None are included with control-see page 7 and inside of door for suitable breakers Wire 4-conductor cable (electronics unit to external chlorination) Wire/conduit for 100A service from main panel to ECOMMAND 4 Wire/conduit for filter pump and other high voltage loads Wire for bonding Miscellaneous Mounting hardware (screws, etc.) for mounting ECOMMAND 4 Valves (use standard Hayward, Pentair/Compool, or Jandy valves) Additional valve actuators Accessory Products - Order Separately AQL2-SS-RF Wireless Spa Side Remote Control (Included with HPC-4-RC, HPC-4-ACT-RC) AQL2-BASE-RF Base Station required if using AQL2-SS-RF (Included with HPC-4-RC, HPC-4- ACT-RC) AQ-CO-HOMENET AquaConnect Web-based application for mobile devices (Web, iOS, Android) AQL2-POD2 AquaPod 2.0 AQL-DIM Light Dimmer Relay GVA-24 Valve Actuator V&A-xx Valve & Actuator (xx=1P (1.5" pos. seal), -2P (2" pos. seal), (Included with HPC-4-ACT, HPC-4-ACT-RC) 2 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS