Hayward Ecommand W/2Gva/Base/Aquaconne ECOMMAND-4-Installation-Manual-092419AR - Page 27

Time Format 12 hour AM/PM Units ºF and PPM Reset Config. to Default Press + Are you sure? + to proceed Config. reset Confirmed Toggle between 12 hour AM/PM (default) and 24 hour time format options Move to previous/next configuration menu Toggle between ºF and PPM (default) and ºC and g/L (Metric) options Move to previous/next configuration menu Initiate reset of all configuration parameters Move to previous/next configuration menu (config. not reset) Reset all configuration parameters Move to previous/next menu (config. not reset) Move to previous/next configuration menu Use this function to erase all previous system configuration and reset all configuration parameters back to the factory default values. This function is NOT reversible--be careful. System Startup and Checkout Before Startup Before starting the ECOMMAND 4 for the first time, be sure that the following items have been completed: 1. Properly rated circuit breakers are installed in the ECOMMAND 4 subpanel. 2. All wiring is performed according to NEC and local codes. 3. The ECOMMAND 4 is properly grounded and bonded. 4. The ECOMMAND 4 is properly configured to control all desired functions. Program Automatic Operation Refer to the programming flow chart on the following page for a listing of the available menus and the items included in each menu. Settings Menu Heater and/or solar thermostat settings Chlorinator settings (if applicable) Day and Time Timers Menu Timeclock and/or Countdown timer settings 26 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS