Hayward Ecommand W/2Gva/Base/Aquaconne ECOMMAND-4-Installation-Manual-092419AR - Page 16

Hayward Aqua Rite or Hayward Swimpure Chlorinator The ECOMMAND 4 can control one or more Hayward Aqua Rite or Hayward Swimpure chlorinators when additional sanitizing capacity is required. A 4 wire connection is used to communicate to the Aqua Rite/Swimpure and can be wired up to 500' apart. Any outdoor rated 4 conductor cable can be used. Refer to the wiring diagrams below for proper wiring connection to the Aqua Rite/ Swimpure. NOTE: There must be only 1 "primary" unit. All other Aqua Rite/Swimpure units must be configured as "secondary". Jumper Installed For Primary (Factory Default) ECOMMAND 4 Aqua Rite or Swimpure (Primary) 4 GREEN 3 YELLOW 2 BLACK 1 RED Jumper Removed For Secondary(s) Aqua Rite or Swimpure (Secondary) Additional Aqua Rite/Swimpure(s) (if required) NOTE: Primary/Secondary jumper is located underneath small circuit board. GRN 4 ECOMMAND 4 YEL BLK 3 2 RED 1 green yellow black red 4 GRN Aqua Rite 3 YEL or 2 BLK Swimpure 1 RED 15 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS