HP 14-an000 Maintenance and Service Guide - Page 52
Discrete graphics, UMA graphics, and processor
View all HP 14-an000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
3. Remove the heat sink assembly from the system board (2). NOTE: Heat sink appearance may vary. Discrete graphics 4. On models with UMA graphics, remove the four Phillips PM2.0×3.0 screws (1) on the heat sink that secure the heat sink assembly to the system board. 5. Remove the heat sink assembly from the system board (2). NOTE: Heat sink appearance may vary. UMA graphics Thermal paste is used on the processor and associated heat sink areas as shown in the following images: ● Discrete graphics Heat sink (1) and processor (2), as well as the heat sink (3) and graphics chip (4). 44 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
3.
Remove the heat sink assembly from the system board
(2)
.
NOTE:
Heat sink appearance may vary.
Discrete graphics
4.
On models with UMA graphics, remove the four Phillips PM2.0×3.0 screws
(1)
on the heat sink that
secure the heat sink assembly to the system board.
5.
Remove the heat sink assembly from the system board
(2)
.
NOTE:
Heat sink appearance may vary.
UMA graphics
Thermal paste is used on the processor and associated heat sink areas as shown in the following images:
●
Discrete graphics
Heat sink
(1)
and processor
(2)
, as well as the heat sink
(3)
and graphics chip
(4)
.
44
Chapter 6
Removal and replacement procedures for Authorized Service Provider parts