HP 2000-150CA Service Guide - Page 53
Remove the Phillips PM2.5×6.0 screw, that secures the optical drive to the computer.
View all HP 2000-150CA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Remove the optical drive: 1. Loosen the captive screw (1) that secures the memory module/wireless module compartment cover to the computer. 2. Lift the rear edge of the memory module/wireless module compartment cover (2) up and forward until it rests at an angle. 3. Remove the memory module/wireless module compartment cover. The memory module/wireless module compartment cover is available in the Plastics Kit, spare part number 646131-001. 4. Remove the Phillips PM2.5×6.0 screw (1) that secures the optical drive to the computer. 5. Insert an unbent paper clip or similar thin tool into the optical drive tab access (2) to release the optical drive tray from the optical drive. Component replacement procedures 45
Remove the optical drive:
1.
Loosen the captive screw
(1)
that secures the memory module/wireless module compartment cover
to the computer.
2.
Lift the rear edge of the memory module/wireless module compartment cover
(2)
up and forward
until it rests at an angle.
3.
Remove the memory module/wireless module compartment cover. The memory module/wireless
module compartment cover is available in the Plastics Kit, spare part number 646131-001.
4.
Remove the Phillips PM2.5×6.0 screw
(1)
that secures the optical drive to the computer.
5.
Insert an unbent paper clip or similar thin tool into the optical drive tab access
(2)
to release
the optical drive tray from the optical drive.
Component replacement procedures
45