HP 2000-150CA Service Guide - Page 84
Remove the system board, Lift the right side of the system board
View all HP 2000-150CA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Remove the system board: 1. Disconnect the optical drive connector cable from the system board. 2. Remove the Phillips PM2.5×6.0 screw (1) that secures the system board to the base enclosure. 3. Lift the right side of the system board (2) until it rests at an angle. 76 Chapter 4 Removal and replacement procedures
Remove the system board:
1.
Disconnect the optical drive connector cable from the system board.
2.
Remove the Phillips PM2.5×6.0 screw
(1)
that secures the system board to the base enclosure.
3.
Lift the right side of the system board
(2)
until it rests at an angle.
76
Chapter 4
Removal and replacement procedures