HP 8/40 Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, Apri - Page 589
Enables or disables Insistent Domain Id IDID for the specified EX_Port., McDATA Open Fabric mode.
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 589 highlights
portCfgEXPort 2 -i mode an error message is posted, and the command fails. Valid values are as follows: 0 Brocade Native mode. 1 McDATA Open Fabric mode. 2 McDATA Fabric mode. 3 MCDATA fabric legacy mode. Note that this mapping between mode values and modes is NOT the same as the mapping used when setting interoperability modes with the interopMode, command. Enables or disables Insistent Domain Id (IDID) for the specified EX_Port. Specify 1 to enable IDID, specify 2 to disable IDID. This command must be issued from a McDATA edge switch attached to a single or dual FCR configuration. Examples To set the fabric ID of port 2/1 to 5 and the port ID format to core: switch:admin> portcfgexport 2/1 -f 5 -p 1 To configure port 2/0 to be an EX_Port and set the fabric ID to 4: switch:admin> portcfgexport 2/0 -a 1 -f 4 To disable fabric parameter negotiation on port 2/0 of an EX_Port: switch:admin> portcfgexport 2/0 -t 2 To enable IDID on port 2: switch:admin>portcfgexport 2 -i 1 To display EX_Port settings configured for Mi10K connectivity: switch:admin> portcfgexport 10 Port 10 info Admin: enabled State: OK Pid format: Not Applicable Operate mode: Open Domain Id mode: 239 Mode Insistent Domain ID Mode: enabled Front WWN: 50:00:51:e3:76:0e:4e:46 Fabric Parameters: Auto Negotiate R_A_TOV: Not Applicable E_D_TOV: Not Applicable Authentication Type: None DH Group: N/A Hash Algorithm: N/A Edge fabric's primary wwn: N/A Edge fabric's version stamp: N/A See Also portCfgVEXPort, portDisable, portEnable, portShow, portCfgDefault, fcrbCastConfig Fabric OS Command Reference 561 53-1001186-01