HP 8/40 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01, July 2009) - Page 615
matching configurations., Modifies the properties of an existing FCIP circuit. To modify a circuit
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 615 highlights
portCfg 2 fcipcircuit Creates an FCIP circuit on an existing tunnel. Use this command to configure additional circuits. The circuit-specific parameters are optional. The syntax for portcfg fcipcircuit is as follows: portcfg fcipcircuit [slot/]ve_port option circuit_ID options [arguments] [optional_arguments] The following options and arguments are supported with fcipcircuit: create circuit_ID remote_ip_addr local_ip_addr comm_rate Creates an FCIP circuit. Specify the following: circuit_ID Specifies a numeric identifier for the circuit. The circuit ID is an integer value between 0-9 both on the Brocade FX8-24 and on the Brocade 7800. remote_ip_addr Specifies the IP address for the remote end of the FCIP circuit. IPv6 addresses are currently not supported. local_ip_addr Specifies the IP address for the local end of the FCIP circuit. IPv6 addresses are currently not supported. The following operands are exclusive: comm_rate Specifies the committed traffic rate on the FCIP tunnel in Kbps. The valid range is 1544 Kbps - 1000000 Kbps. There is no default. Both sides of the tunnel must have matching configurations. --min-comm-rate value, --max-comm-rate value Alternately you may set a minimum and a maximum for the committed rate to configure the tunnel for Adaptive Rate Limiting (ARL), which allows for a more effective sharing of bandwidth between applications. The valid range is 1544 Kbps - 1000000 Kbps. Both sides of the tunnel must have matching configurations. modify [circuit_ID] [circuit_arguments] Modifies the properties of an existing FCIP circuit. To modify a circuit, you must specify at least one of the circuit parameters for the command to be effective. Any circuit attribute you change with the fcipcircuit modify command affects only the specified FCIP circuit. All other circuits remain unchanged. Optional arguments for fcipcircuit create and modify include: -a |--admin-status 0|1 Enables (1) or disables (0) the circuit. -s |--sack 0|1 Disables or enables selective acknowledgement code (SACK) on the FCIP circuit. SACK is by default enabled. -k |--keepalive-timeout timeout Specifies the keep alive timeout in milliseconds. The valid range is 500ms - 7200000ms. The default value is 5000ms. Fabric OS Command Reference 585 53-1001337-01