HP Brocade 8/24c Brocade Fabric OS Command Reference Manual Supporting Fabric - Page 180

22 configure Zoning Operation Parameters The following zoning operation parameter can be modified. Disable NodeName Zone Checking Specify 1 to disable using node WWN when specifying nodes in the zone database. Specify 0 to enable using node WWN when specifying nodes in the zone data. The default value is 0. This value must be set to 1 for interpretability. RSCN Transmission Mode The RSCN transmission modes and values are as follows: End-device RSCN Transmission Mode Values are as follows: 0 RSCN only contains single PID 1 RSCN contains multiple PIDs (Default) 2 Fabric addresses RSCN Domain RSCN to End-device Values are as follows: 0 Disabled. No domain RSCN is sent to the end-device for the switch IP address or name change. 1 Enabled. Domain RSCN is sent to the end-device for the switch IP address or name change. Arbitrated Loop Parameters Arbitrated Loop Parameter and their values are as follows: Send FAN frames? Specifies that fabric address notification (FAN) frames be sent to public loop devices to notify them of their node ID and address. When set to 1, frames are sent; when set to 0, frames are not sent. The default value is 1. Enable CLOSE on OPEN received? If this is set, a CLS is returned immediately to an OPN if no buffers are available. This is required for TachLite. The valid range is 0 to 4. The default value is 0. Always send RSCN? Following the completion of loop initialization, a remote state change notification (RSCN) is issued when FL_Ports detect the presence of new devices or the absence of preexisting devices. When set to 1, an RSCN is issued upon completion of loop initialization, regardless of the presence or absence of new or preexisting devices. When set to 0, an RSCN is not sent (default). System Services Settings The values for the System Services settings are as follows: Disable RLS probing Enables or disables the read link status (RLS) probing. Performed by the FCP daemon, RLS probing reads the link error block from the device. This extended link services command is defined by the FC standards. Refer to the FC standards for information. RLS probing is enabled by default, meaning "Disable RLS probing" is "off". "on" disables RLS probing. 146 Fabric OS Command Reference 53-1001764-01