HP Brocade 8/24c Brocade Fabric OS Command Reference Manual Supporting Fabric - Page 474

22 ipAddrSet • Use the -auto and -noauto options to enable or disable stateless IPv6 autoconfiguration. • Use the -ls option with appropriate arguments to set or delete the IPv4 Fibre Channel address and prefix for the IPFC interface of a logical switch. In a Virtual Fabric environment, each logical fabric is represented by a separate IPFC network interface. Each of these network interfaces can be assigned a unique IPv4 FC address and prefix. The logical switches that make up a logical fabric are identified by the fabric ID (FID) that is assigned to each of the logical switch instances. When setting the IPFC interface of a switch that is not in Virtual Fabric mode, use the -ls option with FID 128. FID 128 identifies the switch when Virtual Fabrics are disabled. Setting IP addresses interactively (IPv4 Ethernet address only): • To set the CP Ethernet IPv4 address, use the -cp option; to set the Ethernet IP address for the entire chassis, use the -chassis option. When setting the chassis IP address, the command prompts for the Ethernet IP address and Ethernet subnet mask. When setting the CP Ethernet IP address, the command prompts for the host name, Ethernet IP address, Ethernet subnet mask, and Gateway IP address. Valid switch and CP numbers depend on the platform on which the command is run. The command must be executed on the active CP. • On most standalone platforms (with the exception of the AP7600), ipAddrSet runs interactively if invoked without operands. The command prompts for the Ethernet IP address, Ethernet subnet mask, and Gateway IP address. In addition, the command prompts for a specification of whether the Dynamic Host Control Protocol (DHCP) should be used to acquire the Ethernet IP address, Ethernet subnet mask and Gateway IP address. Valid entries are "On" to enable DHCP and "Off" to disable it. When DHCP is enabled, any user-configured Ethernet IP address, Ethernet subnet mask or Gateway IP address is ignored. NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. OPERANDS When used in command line mode, the following operands are supported: -Ipv6 Specifies IP address type as static IPv6 including prefix as needed. --add x:x:x:x:x:x:x/n Sets the specified IPv6 address. --delete [x:x:x:x:x:x:x/n] Deletes the specified IPv6 address. If no address is specified, any existing IPv6 addresses and prefixes are deleted from the specified or implied entity. -cp cp_number Specifies the CP on a chassis. Valid values are 0 or 1. -chassis Specifies the IPv6 address and prefix of a chassis. On platforms with blade processors, the following additional command line options are supported with the --add or --delete options: -eth0 | -eth1 Specifies the local IPv4 address of the blade processor. A prefix is required. -gate Specifies the IPv4 address of the blade processor (BP) Gateway (no prefix). -slot number On a chassis with a blade processor (BP), specifies the slot number. On standalone platforms with a hidden BP, such as the AP76500, this parameter is not accepted. 440 Fabric OS Command Reference 53-1001764-01