HP Brocade 8/24c Brocade Fabric OS Command Reference Manual Supporting Fabric - Page 655
switchShow, portcfg arp, portShow arp, delete, flush, fciptunnel, portCfg fciptunnel, portcfg, create
View all HP Brocade 8/24c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 655 highlights
22 portCfg OPERANDS This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). ge_port Specifies the number of the port to be configured, relative to its slot for bladed systems. The GbE ports on the Brocade FR4-18i are numbered ge0 - ge1. Use the switchShow command for a list of valid ports. arp Optionally adds entries to the address resolution protocol (ARP) table or deletes entries from ARP table. Can also be used to flush the entire table. The syntax for portcfg arp is as follows: portcfg arp [slot/][ge]port options arguments Valid options and arguments for arp include the following: add ipaddr macaddr Adds a static ARP entry to the ARP table. Specify an IP address and a MAC address for each entry. Use portShow arp with the -lmac option to get the MAC address. delete ipaddr Deletes a static ARP entry from the ARP table. Only the IP address must be specified to delete the entry. flush Flushes the ARP table. Only dynamic entries can be flushed, static entries cannot be cleared. fciptunnel Creates, modifies, or deletes a Fibre Channel over IP (FCIP) tunnel. You can configure up to a maximum of eight FCIP tunnels per GbE port. The syntax for portCfg fciptunnel is as follows: portcfg fciptunnel [slot/][ge]port options arguments [optional_arguments] The following options and arguments are supported with fciptunnel: create tunnel_id dest_ipaddr src_ipaddr comm_rate Creates an FCIP tunnel. You must specify a tunnel ID, destination and source IP address, and committed rate when creating an FCIP tunnel. Other configuration parameters are optional, and can be added later. tunnel_id Specifies the FCIP tunnel on the GbE port. Valid values are 0 to 7. dest_ipaddr Specifies the IP address for the remote end of the FCIP tunnel. src_ipaddr Specifies the IP address for the local end of the FCIP tunnel. comm_rate Specifies the committed traffic rate on the FCIP tunnel in Kbps. Valid range is 1,544 to 1,000,000. Specify 0 for an uncommitted tunnel. Uncommitted tunnels compete for bandwidth. Changing comm_rate is potentially disruptive. Fabric OS Command Reference 621 53-1001764-01