HP Chromebox G3 Maintenance and Service Guide - Page 36

Remove the Phillips M2.0 × 2.9 screw, terminal. The #2/Aux

Page 36 highlights

NOTE: The #1/Main WLAN antenna cable connects to the WLAN module #1/Main terminal. The #2/Aux WLAN antenna cable connects to the WLAN module #2/Aux terminal. 2. Remove the Phillips M2.0 × 2.9 screw (2) that secures the WLAN module to the system board. (The WLAN module tilts up.) 3. Remove the WLAN module (3) by pulling the module away from the slot at an angle. NOTE: WLAN modules are notched to prevent incorrect installation. 4. If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective sleeve on the antenna connector, as shown in the following illustration. Reverse this procedure to install the WLAN module. 32 Chapter 6 Removal and replacement procedures for authorized service provider parts ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58

NOTE:
The #1/Main WLAN antenna cable connects to the WLAN module
#1/Main
terminal. The #2/Aux
WLAN antenna cable connects to the WLAN module
#2/Aux
terminal.
2.
Remove the Phillips M2.0 × 2.9 screw
(2)
that secures the WLAN module to the system board. (The WLAN
module tilts up.)
3.
Remove the WLAN module
(3)
by pulling the module away from the slot at an angle.
NOTE:
WLAN modules are notched to prevent incorrect installation.
4.
If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective sleeve on
the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
32
Chapter 6
Removal and replacement procedures for authorized service provider parts
ENWW