HP ENVY 14-3010nr HP ENVY14 SPECTRE Maintenance and Service Guide IMPORTANT! T - Page 70

The thermal material must be thoroughly cleaned from the surfaces of the post controller hub heat sink

Get HP ENVY 14-3010nr PDF manuals and user guides View all HP ENVY 14-3010nr manuals
Add to My Manuals
Save this manual to your list of manuals

Page 70 highlights

Reverse this procedure to install the processor heat sink. Remove the post controller hub heat sink: 1. Loosen the captive Philllips screw (1) that secures the post controller hub heat sink to the system board. 2. Remove the post controller hub heat sink (2). NOTE: Due to the adhesive quality of the thermal material located between the post controller hub heat sink and system board, it may be necessary to move the post controller hub heat sink from side to side to detach it. The thermal material must be thoroughly cleaned from the surfaces of the post controller hub heat sink and the post controller hub each time the post controller hub heat sink is removed. Replacement thermal material is included with the post controller hub heat sink and system board spare part kits. 62 Chapter 4 Removal and replacement procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
Reverse this procedure to install the processor heat sink.
Remove the post controller hub heat sink:
1.
Loosen the captive Philllips screw
(1)
that secures the post controller hub heat sink to
the system board.
2.
Remove the post controller hub heat sink
(2)
.
NOTE:
Due to the adhesive quality of the thermal material located between the post controller
hub heat sink and system board, it may be necessary to move the post controller hub heat sink
from side to side to detach it.
The thermal material must be thoroughly cleaned from the surfaces of the post controller hub heat sink
and the post controller hub each time the post controller hub heat sink is removed. Replacement thermal
material is included with the post controller hub heat sink and system board spare part kits.
62
Chapter 4
Removal and replacement procedures