HP Jetdirect en1700 HP Jetdirect Print Server Administrator's Guide (Firmware - Page 186
Execute, Ping Results, Packets Sent, Packets Received, Percent Lost, RTT Min, RTT Average
View all HP Jetdirect en1700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 186 highlights
Table C-1 Jetdirect EIO Menu on Graphical Control Panel (continued) Menu item Sub-menu item Sub-menu item Values and Description No (default): Results are not printed Execute Specify whether to initiate the ping test. No (default): Do not run the test. Yes: Run the test Ping Results Use this item to view the ping test status and results using the control panel display. Packets Sent Shows the number of packets (0 - 65535) sent to the remote host since the most recent test was initiated or completed. Packets Received Shows the number of packets (0 - 65535) received from the remote host since the most recent test was initiated or completed. Percent Lost Shows the percent of ping test packets that were sent with no response from the remote host since the most recent test was initiated or completed. RTT Min Shows the minimum detected roundtrip- time (RTT), from 0 to 4096 milliseconds, for packet transmission and response. RTT Max Shows the maximum detected roundtrip- time (RTT), from 0 to 4096 milliseconds, for packet transmission and response. RTT Average Shows the average round-trip-time (RTT), from 0 to 4096 milliseconds, for packet transmission and response. Ping in Progress Shows whether a ping test is in progress. Yes indicates a test in progress, and No indicates that a test completed or was not run. Refresh When viewing the ping test results, this item updates the ping test data with current results. Yes: Update the data. No: Maintain the existing data. However, a refresh automatically occurs when the menu times out or you manually return to the main menu. Link Speed The link speed and communication mode of the print server must match the network. The available settings depend on the device and installed print server. Select one of the following link configuration settings: CAUTION: If you change the link setting, network communications with the print server and network device might be lost. Auto (default): The print server uses auto-negotiation to configure itself with the highest link speed and communication mode allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set depending on the detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.) 176 Appendix C HP Jetdirect Control Panel Menus (V.36.xx) ENWW