HP Kayak XU 03xx HP Kayak XU Series 03xx, Accessories Installation Guide - Page 22

Before Installing an, IDE Device, SCSI Device

Get HP Kayak XU 03xx PDF manuals and user guides View all HP Kayak XU 03xx manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

HP Kayak XU 03xx PC Workstation - Installing Accessories In Your HP PC Workstation Installing Mass Storage Devices Before Installing an IDE Device Before Installing a SCSI Device Refer to the drive's installation guide to see if you must set jumpers or if there is a special installation procedure to follow. If you are installing a SCSI device, refer to the section "Before Installing a SCSI Hard Disk" on page 15 before using the following instructions. 1 Disconnect the computer's power cord and any telecommunications cable. 2 Remove the computer's cover (refer to page 3). 3 Slide out the power supply to provide better access to the disk drive cables (see page 6). 4 If installing a drive in a 5.25-inch wide shelf, remove the drive tray and put it in a safe place. Remove the drive tray if installing a 5.25-inch drive Secure the drive Mounting Rails in position Slide the drive into position 5 Slide the drive into the shelf. 6 Secure the drive in position using the screws provided with the drive. 7 Locate the appropriate data cable for the device. 22 English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
HP Kayak XU 03xx PC Workstation
— Installing Accessories In Your HP PC Workstation
Installing Mass Storage Devices
22
English
Before Installing an
IDE Device
Refer to the drive’s installation guide to see if you must set jumpers or
if there is a special installation procedure to follow.
Before Installing a
SCSI Device
If you are installing a SCSI device, refer to the section “Before Installing
a SCSI Hard Disk” on page 15 before using the following instructions.
1
Disconnect the computer’s power cord and any telecommunications
cable.
2
Remove the computer’s cover (refer to page 3).
3
Slide out the power supply to provide better access to the disk drive
cables (see page 6).
4
If installing a drive in a 5.25-inch wide shelf, remove the drive tray
and put it in a safe place.
5
Slide the drive into the shelf.
6
Secure the drive in position using the screws provided with the
drive.
7
Locate the appropriate data cable for the device.
Remove the
drive tray if
installing a
5.25-inch drive
Slide the drive
into position
Mounting Rails
Secure the drive
in position