HP Kayak XU 03xx HP Kayak XU Series 03xx, Accessories Installation Guide - Page 8

CAUTION NOTE HP Kayak XU 03xx PC Workstation - Installing Accessories In Your HP PC Workstation Installing Memory Installing Memory Main Memory Modules If you need more main memory to run your application software, you can install up to 1GB of memory in four DIMM slots. Main memory upgrades are available in single 32 MB, 64 MB and 128 MB Unbuffered ECC SDRAM or 256 MB Registered ECC SDRAM memory modules. You should note that Registered ECC SDRAM cannot be used with Unbuffered memory modules. Do not attempt to combine these two types of memory. Static electricity can damage electronic components. Turn off all equipment. Do not let your clothes touch the accessory. To equalize the static electricity, rest the accessory bag on top of the power supply while you are removing the accessory from the bag. Handle the accessory as little as possible and with care. To install a main memory module: 1 Disconnect the computer's power cord and any LAN or telecommunications cable. 2 Remove the computer's cover (refer to page 3). 3 Press the retaining buttons on each side of the HP UltraFlow airflow guide and lift it partly out of the PC Workstation's case. 4 Remove the fan connection to the system board and lift the airflow guide completely out of PC Workstation's case. Refer to the illustration on page 6 for steps 3 and 4. 5 Remove the Ultra wide 16-bit SCSI cable from the system board. 6 Remove the power supply and the transparent airflow guide covering the processor sockets (if needed). 7 Remove the floppy disk drive data cable from the system board. 8 English