HP Kayak XW U3-W3 HP Kayak XW (Series U3-W3), Accessories Installation Guide - Page 12
Which Power, Connectors to Use, Installing a Hard, Disk Drive
![]() |
View all HP Kayak XW U3-W3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
HP Kayak XW U3 & W3 PC Workstation - Installing Accessories In Your HP PC Workstation Installing Mass Storage Devices Which Power Connectors to Use There are two different types of power connectors-these are shown below. Power Cables for Hard Disk Drives, Zip Drives, Tape Drives, CD-RW, and CD-ROM Drives Installing a Hard Disk Drive Power Cable for 3.5-inch Flexible Disk Drive Some of the power connectors will already be connected to devices. If you install a device that requires a different connector, the connector converter should be supplied with the device. This PC Workstation has an integrated Ultra SCSI controller, an Ultra SCSI interface board and an integrated Ultra ATA-33 IDE controller. • The Ultra ATA-33 IDE controller, on the PCI bus, supports up to two fast (33 MB per second) IDE devices. • The Ultra wide 16-bit SCSI controller is dedicated to hard disk drives and supports up to five internal SCSI devices. • The Ultra SCSI 16-bit interface board, installed in a PCI slot, supports up to 13 external 16-bit SCSI devices and automatically switches to non-Ultra or standard mode (data transfer rate of 20 MB per second). The Ultra 8-bit internal connector supports up to two internal peripherals at up to 20 MB per second. 12 English
![](/manual_guide/products/hewlettpackard-kayak-xw-u3w3-hp-kayak-xw-series-u3w3-accessories-installation-guide-80cf6a5/12.png)