HP Kayak XW U3-W3 HP Kayak XW (Series U3-W3), Accessories Installation Guide - Page 16

Installing a Hard Disk Drive in a Front-Access Shelf, Remove the computer's cover refer

Get HP Kayak XW U3-W3 PDF manuals and user guides View all HP Kayak XW U3-W3 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

NOTE HP Kayak XW U3 & W3 PC Workstation - Installing Accessories In Your HP PC Workstation Installing Mass Storage Devices 9 Connect the power cable and the data cable to the rear of the drive. (The connectors are shaped to go in one way only.) Data Cable Power Cable 10 Install any other accessories before completing the installation. 11 Turn to page 19 to complete the installation. Installing a Hard Disk Drive in a Front-Access Shelf To ensure your hard disk drive is properly located and cooled, you should only install drives that are up to one inch (1") in height and of a speed equal to or less than 7200 rpm in this shelf. 1 Disconnect the computer's power cord and any telecommunications cable. 2 Remove the computer's cover (refer to page 3). 3 Remove the fan connection to the system board (refer to page 6). 4 Press the retaining buttons on each side of the HP UltraFlow airflow guide and lift it out of the PC Workstation's case. 5 Slide out the power supply to provide better access to the disk drive cables (refer to page 6). 6 Unscrew and remove an unused drive tray. 16 English Remove the drive tray

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
HP Kayak XW U3 & W3 PC Workstation
— Installing Accessories In Your HP PC Workstation
Installing Mass Storage Devices
16
English
9
Connect the power cable and the data cable to the rear of the drive.
(
The connectors are shaped to go in one way only
.)
10
Install any other accessories before completing the installation.
11
Turn to page 19 to complete the installation.
Installing a Hard Disk Drive in a Front-Access Shelf
NOTE
To ensure your hard disk drive is properly located and cooled, you
should only install drives that are up to one inch (1”) in height and of a
speed equal to or less than 7200 rpm in this shelf.
1
Disconnect the computer’s power cord and any telecommunications
cable.
2
Remove the computer’s cover (refer to page 3).
3
Remove the fan connection to the system board (refer to page 6).
4
Press the retaining buttons on each side of the HP UltraFlow airflow
guide and lift it out of the PC Workstation’s case.
5
Slide out the power supply to provide better access to the disk drive
cables (refer to page 6).
6
Unscrew and remove an unused drive tray.
Data Cable
Power Cable
Remove the
drive tray