HP Kayak XW U3-W3 HP Kayak XW (Series U3-W3), Accessories Installation Guide - Page 28
Completing the, Installation of a, Processor, Windows NT 4.0 on your PC Workstation.
View all HP Kayak XW U3-W3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Completing the Installation of a Processor NOTE HP Kayak XW U3 & W3 PC Workstation - Installing Accessories In Your HP PC Workstation Installing a Processor 1 Verify that the system board bus speed switches are correctly configured for the processor. If two processors are installed, both must operate at the same bus speed and processor speed. Refer to the manual supplied with the processor to verify which bus and processor speeds are supported. NOTE Switch 1 UP1 Switch 2 UP Switch 3 UP Switch 4 DOWN Switch 5 DOWN External Bus Speed 100 MHz Processor Speed 350 MHz UP UP DOWN UP UP 100 MHz 400 MHz UP UP DOWN UP DOWN 100 MHz 450 MHz UP UP DOWN DOWN UP 100 MHz 500 MHz 1. UP=OFF, DOWN=ON. 2 Install any other accessories before completing the installation of the processor. 3 Replace the cover (refer to page 4). 4 Turn on the computer and check that the new processor is recognized by the power-on system-test. To fully benefit from dual processing, you will need to re-install Windows NT 4.0 on your PC Workstation. 28 English