HP LH4r HP Netserver LXr 8000 PCI Hot Plug Replacement - Page 11
Slots, Amber LED, Green LED, PCI Non-Hot Swap Slots, PCI Hot-Swap, Shared PCI/ISA
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Chapter 6 Addendum HP NetServer LXr 8000 Installation Guide 10. Consider the boot priority before any installing any accessory board. If installing a SCSI controller board, the controller's priority (BIOS search order for a boot drive) is set by the board's slot location. For details, refer to the section "Boot Priority" earlier in this chapter. 11. Identify the desired slot, before installing the accessory board. See Figure 6-5. 10 9 8 7 6 5 4 3 2 1 PCI Hot-Swap Slots Amber LED Green LED Shared PCI/ISA Slot PCI (Non-Hot Swap) Slots Figure 6-5. I/O Slot Layout 12. If installing a new board into an unused slot, remove its slot cover on the NetServer's rear panel after selecting the slot. CAUTION Do not bend the PCI board to install it into the slot. If full-length PCI boards have a handle on the end of the board that prevents its installation, remove the handle before installing the board. 13. If the PCI board is a full-length board with a handle attached to it, remove the handle before installing the board into the slot. 9