HP LH4r HP Netserver LXr 8000 PCI Hot Plug Replacement - Page 12
See
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Chapter 6 Addendum 14. Align the board along its slot and position it in the slot. 15. Push the board down into its connector on the I/O baseboard. HP NetServer LXr 8000 Installation Guide Figure 6-6. Installing the Accessory Board 16. Insert the screw in the accessory board's bracket and secure it to the HP NetServer's rear panel. See Figure 6-6. 17. If the installed accessory board requires a connection to the I/O baseboard, system board, or chassis, ensure that the cable is properly attached. Refer to the accessory board documentation for connection requirements. 18. If all desired accessory boards have been installed, re-install all covers. CAUTION To prevent damage to cables, or a disruption in service due to a disconnection of cables, use caution when sliding the chassis into the rack. 19. If chassis work is complete, slide it back into the rack. See Figure 6-7. 20. Use a T-25 screwdriver to screw the flanges to the rack front columns. See Figure 6-7. 21. Re-install the bezel onto the front of the NetServer. 10