HP LH4r Pedestal-to-Rack Conversion Guide - Page 14
CAUTION, If you open the HP NetServer LH 3/3r or LH 4/4r while it is
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Chapter 2 Remove Bezel, Cover, and Components WARNING Before removing the cover, always disconnect the power cord(s) and unplug telephone cables. Disconnect the power cord(s) to avoid exposure to high energy levels that may cause burns when parts are short-circuited by metal objects, such as tools or jewelry. Disconnect telephone cables to avoid exposure to shock hazard from telephone ringing devices. Note that the power switch does not turn off the standby power. Disconnect the power cord(s) to turn off standby power. If the backlight on the LCD display is on, standby power is still on. CAUTION Never operate this HP NetServer without first installing the covers and the front bezel. Operating the system without the covers in place reduces critical cooling airflow over some components, such as power supply modules, hard disk drives, and processor modules. Operating the system without the covers in place may result in failure of these components. If you open the HP NetServer LH 3/3r or LH 4/4r while it is operating, do not run it for more than 2 minutes. If you open the HP NetServer LH 3000/3000r or LH 4000/4000r while it is operating, do not run it for more than 60 minutes. Failure to observe these precautions may result in thermal damage to the NetServer. CAUTION Wear a wrist strap and use a static-dissipating work surface connected to the chassis when you remove or install components. 10