HP LH4r Pedestal-to-Rack Conversion Guide - Page 35
Replace Power Supply Modules and Hard Disk Drives, are seated correctly
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Chapter 3 Conversion: Install Components, Cover, and Front Bezel 10. Plug the HP NetServer's power cable and all available data cables into the back of the HP NetServer. Replace Power Supply Modules and Hard Disk Drives Do the following to replace the power supply modules and hot-swap hard disk drive modules: 1. Refer to the NetServer's user guide or installation guide to replace the power supply modules in the power supply cage. Ensure that the modules are seated correctly, and then fasten the thumbscrews. 2. Refer to the NetServer's user guide or installation guide to replace the hard disk drive modules in the hot-swap mass storage cage. Make sure the locking pin engages the cage lip and secures the module in position. 31
Chapter 3
Conversion: Install Components, Cover, and Front Bezel
31
10.
Plug the HP NetServer's power cable and all available data cables into the
back of the HP NetServer.
Replace Power Supply Modules and Hard Disk
Drives
Do the following to replace the power supply modules and hot-swap hard disk
drive modules:
1.
Refer to the NetServer's user guide or installation guide to replace the
power supply modules in the power supply cage. Ensure that the modules
are seated correctly, and then fasten the thumbscrews.
2.
Refer to the NetServer's user guide or installation guide to replace the hard
disk drive modules in the hot-swap mass storage cage. Make sure the
locking pin engages the cage lip and secures the module in position.