HP LH4r Pedestal-to-Rack Conversion Guide - Page 33

Attaching the Cable Management Arm

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

Chapter 3 Conversion: Install Components, Cover, and Front Bezel Compaq Rack Figure 3-7. Mounting Hardware for Front Bezel for Compaq Rack Attaching the Cable Management Arm The Cable Management Arm for the HP NetServer can only be mounted on HP Systems racks. The HP NetServer Cable Management Arm allows the cables, including the power cords, to move in and out with the HP NetServer chassis on its slides without being accidentally disconnected (see Figure 3-8). WARNING Before sliding out the HP NetServer, ensure the anti-tip foot from under the front of the rack is extended or the anti-tip feature is installed. A tip-over hazard exists, so never slide more than one component out of the rack at a time. 1. Ensure the HP NetServer is pushed all the way into the rack. 2. At the rear of the NetServer, place rack nuts on the left column in the 17th and 18th holes above the baseline of the HP NetServer (see Figure 3-8). 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Chapter 3
Conversion: Install Components, Cover, and Front Bezel
29
Compaq
Rack
Figure 3-7. Mounting Hardware for Front Bezel for Compaq Rack
Attaching the Cable Management Arm
The Cable Management Arm for the HP NetServer can only be mounted on HP
Systems racks. The HP NetServer Cable Management Arm allows the cables,
including the power cords, to move in and out with the HP NetServer chassis on its
slides without being accidentally disconnected (see Figure 3-8).
WARNING
Before sliding out the HP NetServer, ensure the anti-tip foot
from under the front of the rack is extended or the anti-tip
feature is installed. A tip-over hazard exists, so never slide
more than one component out of the rack at a time.
1.
Ensure the HP NetServer is pushed all the way into the rack.
2.
At the rear of the NetServer, place rack nuts on the left column in the 17th
and 18th holes above the baseline of the HP NetServer (see Figure 3-8).