HP LH4r Pedestal-to-Rack Conversion Guide - Page 26
Reorient Control Panel to NetServer Chassis
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Chapter 3 Conversion: Install Components, Cover, and Front Bezel 4. Rotate the control panel until it is aligned with the rack position of the NetServer, as shown in Figure 3-3. Be careful of the ribbon cable that connects the control panel to the NetServer. Be careful not to damage it. Compaq rack slots (on left) HP rack slots (on right) Control Panel Figure 3-3. Reorient Control Panel to NetServer Chassis NOTE There are two possible positions for the reinstallation of the control panel, depending upon the rack in which the NetServer will reside. Refer to Figure 3-3. 5. Refer to Figure 3-3. Mount the control panel in the set of slots appropriate for your rack: ◊ Slots for the HP rack are on the right. ◊ Slots for the Compaq rack are on the left. 22