HP LaserJet 5L Service Manual - Page 117
DC Controller
View all HP LaserJet 5L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Note Figure 6-40 DC Controller 1 Remove the Printer Covers. 2 Disconnect the motor connector from the motor (Figure 6-39, callout 1). 3 Disconnect the Solenoid connector from the DC Controller (Figure 6-22, callout 1). 4 Remove the back sheet metal plate and disconnect the PS202/PS204 connector (Figure 6-29). 5 Remove the AC Cable cover and disconnect the AC Cable from the DC Controller (Figures 6-13 and 6-14). 6 Tip the printer on its top, with the front facing you. 7 Remove the (4) screws (Figure 6-40, callout 1). One of the screws is a grounding screw. The location of the grounding screw is marked by a "star" etched into the bottom of the DC Controller. Make certain when you reinstall the DC Controller that the grounding screw with the washer is replaced in the same location. DC Controller Removal (1 of 3) 6 - 44 Removal and Replacement