HP LaserJet 5L Service Manual - Page 89
Fuser Pressure Plate Replacement
View all HP LaserJet 5L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Figure 6-12 To reinstall: The Fuser Pressure Plate is kept in place by four locking mechanisms in each corner. Place the rear slits in the plate over the rear brackets that hold the Fusing Assembly (Figure 6-12, callout 1). Lower the plate over the retaining clips, pressing on both sides of the Fuser Pressure Plate (Figure 6-12, callout, 2). It is important that the spring is placed over the positioning pin (callout 3) because inadequate pressure will cause fusing problems. Replace the screws. Fuser Pressure Plate Replacement 6 - 16 Removal and Replacement
To reinstall:
The Fuser Pressure Plate is kept in place by four locking mechanisms in each
corner. Place the rear slits in the plate over the rear brackets that hold the Fusing
Assembly (Figure 6-12, callout 1). Lower the plate over the retaining clips, pressing
on both sides of the Fuser Pressure Plate (Figure 6-12, callout, 2). It is important
that the spring is placed over the positioning pin (callout 3) because inadequate
pressure will cause fusing problems. Replace the screws.
Fuser Pressure Plate Replacement
Figure 6-12
6 - 16
Removal and Replacement