HP LaserJet 5L Service Manual - Page 85
Exit Roller Assembly
View all HP LaserJet 5L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Figure 6-8 Exit Roller Assembly 1 Remove Printer Covers. 2 Grasp both tabs at the lower ends of the Exit Roller bushings and pull inward. This will release the tabs from the printer chassis (Figure 6-8, callout 1). 3 Rotate the tabs 90 degrees, clear of the printer chassis (Figure 6-8, callout 2). 4 Lift the roller out. Exit Roller Removal To reinstall The end of the Exit Roller that has a gear attached must fit into the gear train. It is possible to reinstall the Exit Roller so that the gear end is on the opposite side of the printer; this placement would cause paper path problems. 6 - 12 Removal and Replacement
Exit Roller Assembly
1
Remove Printer Covers.
2
Grasp both tabs at the lower ends of the Exit Roller bushings and pull inward. This
will release the tabs from the printer chassis (Figure 6-8, callout 1).
3
Rotate the tabs 90 degrees, clear of the printer chassis (Figure 6-8, callout 2).
4
Lift the roller out.
Exit Roller Removal
To reinstall
The end of the Exit Roller that has a gear attached must fit into the gear train. It is
possible to reinstall the Exit Roller so that the gear end is on the opposite side of the
printer; this placement would cause paper path problems.
Figure 6-8
6 - 12
Removal and Replacement