HP Latex 820 HP Scitex LX850 & LX820 Printer: Installation Guide - Page 25
Lower the feet, Officeability Covers
![]() |
View all HP Latex 820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Lower the feet 1. Use a 30 mm wrench to unlock the nut at the top of the foot. 2. Rotate the nut manually down the bolt. Leave about 0.8 inches (2 cm) of clearance at the bottom between nut and foot. 3. Use a 15 mm wrench to rotate the foot downwards. Use the flat faces at the bottom of the bolt to fit the wrench. 4. Lower the foot as far as the bolt allows. 5. Once the wheels are 15 mm (A) off the ground, tighten the 30 mm locking nut against the printer structure NOTE: The right side of the printer is heavier than the left side. Therefore, the feet on the right side will be more difficult to lower. NOTE: The position of the feet must be parallel with the spindle. Officeability Covers Some areas of the printer have lockable covers, the key for these covers is taped to the front scan beam. ENWW Lower the feet 21
![](/manual_guide/products/hewlettpackard-scitex-lx850-hp-scitex-lx850-lx820-printer-installation-guide-6e455e6/25.png)