HP Latex 820 HP Scitex LX850 & LX820 Printer: Installation Guide - Page 40

Cancel, Purge and Setup Menu, 3ph AC Volt, Setup Menu, Con the voltage

Get HP Latex 820 PDF manuals and user guides View all HP Latex 820 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

NOTE: The printer will automatically start in diagnostic mode so you can purge the ink system. 6. If a language has not previously been selected during the boot up sequence, while it is marked 'initializing', press on OK or Cancel key to continue. If no key is pressed, the printer will stay in this 'initializing' status. When you first turn on the printer, you must set the voltage according to the country of installation. Configure the voltage 1. From the front panel, enter the diagnostic menu and select Purge and Setup Menu > 3ph AC Volt Setup Menu to display a list of voltages. 2. Select the correct voltage according to the country of installation and press OK. NOTE: Select the tri-phase nominal mains voltage (line to line) according to the Electrical Installation section of the Site Preparation checklist. 3. Press the Power enable button on the rear side of the printer. It should light up orange. 36 Chapter 6 Configure the electrical system ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
NOTE:
The printer will automatically start in diagnostic mode so you can purge the ink system.
6.
If a language has not previously been selected during the boot up sequence, while it is marked
‘initializing’, press on
OK
or
Cancel
key to continue. If no key is pressed, the printer will stay in this
‘initializing' status.
When you first turn on the printer, you must set the voltage according to the country of installation.
Configure the voltage
1.
From the front panel, enter the diagnostic menu and select
Purge and Setup Menu
>
3ph AC Volt
Setup Menu
to display a list of voltages.
2.
Select the correct voltage according to the country of installation and press
OK
.
NOTE:
Select the tri-phase nominal mains voltage (line to line) according to the Electrical
Installation section of the Site Preparation checklist.
3.
Press the
Power enable
button on the rear side of the printer. It should light up orange.
36
Chapter 6
Configure the electrical system
ENWW