HP M1522nf Service Manual - Page 191

Problem Cause Solution The product is not answering incoming fax calls. A voice-messaging service might be Do one of the following: interfering with the product as it attempts to answer calls. ● Disable the messaging service. ● Get a telephone line that is dedicated to fax calls. ● Set the product answer mode to Manual. In manual mode, you must start the fax-receive process yourself. ● Leave the product set to automatic mode and lower the rings-toanswer setting for the product to a number less than the rings-toanswer setting for the voice mail. The product will answer all incoming calls. The product might be out of paper and the memory is full. Refill the media input tray. Press OK. The product prints all of the faxes it has saved in memory and then resumes answering fax calls. Faxes are not printing. The media input tray is empty. Load media. Any faxes that are received while the input tray is empty are stored in memory and will print after the tray has been refilled. The receive-to-PC option might be selected, and faxes are being received by the computer. Check to determine whether the computer is receiving faxes. Faxes are printing on two pages instead The auto reduction setting might not be Turn on the auto reduction setting. of one. set correctly. The incoming faxes might have been sent on larger media. Adjust the auto reduction setting to allow larger pages to be printed on one page. Received faxes are too light or are printing only on half of the page. The product ran out of toner while printing a fax. The product stores the most recently printed faxes. (The amount of memory that is available determines the actual number of faxes stored for reprinting.) As soon as possible, replace the print cartridge, and then reprint the fax. The fax that was sent was too light. Contact the sender and have the sender resend the fax after altering the settings. ENWW Fax problems (fax models only) 173