HP M3027 Service Manual - Page 125
Disk drive
UPC - 882780570054
View all HP M3027 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Disk drive 1. Remove the right-side cover (see Right-side cover on page 94) and the formatter shield (see Formatter shield on page 95). 2. Disconnect two cables (callout 1) and remove one screw (callout 2). 2 1 Figure 5-34 Removing the disk drive (1 of 3) 3. Slide the disk drive up slightly to clear three tabs from the tab slots (callout 3 in Figure 5-35 Removing the disk drive (2 of 3) on page 114), and then lift the disk drive away from the device. Reinstallation tip Upon reinstallation, make sure that all three tabs are inserted correctly into the slots. Also make sure that the screw-hole tab on the disk drive housing is on top of the tab in the device. NOTE If you are replacing the disk drive, complete the additional steps below. If you are removing the disk drive in order to replace the formatter or other parts, there is no need to complete the remaining steps in this section. ENWW Disk drive 113