HP M3027 Service Manual - Page 128

Formatter 1. Remove the following components: ● Right-side cover (see Right-side cover on page 94) ● Formatter shield (see Formatter shield on page 95) ● Disk drive (see Disk drive on page 113) NOTE Removing the disk drive is not a required step. However, you might find it easier to remove the formatter if you have already removed the disk drive. 2. Disconnect three cables (callout 1) from the top of the formatter. 3. Disconnect four cables (callout 2) from the left side (toward the front of the device) of the formatter. 4. Remove six screws (callout 3). 1 2 3 Figure 5-37 Removing the formatter 5. Lift up the formatter slightly to clear one tab at the bottom, rotate the left edge of the formatter (at the front of the device) away from the device, and then slide the formatter toward the front of the device to remove it. 116 Chapter 5 Removal and replacement ENWW