HP OMEN 17-an000 Maintenance and Service Guide - Page 64
USB board, Remove the USB board
![]() |
View all HP OMEN 17-an000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
USB board Description USB board (for use in products equipped with N17E processors only (GTX 1070/1060) USB board (for use in products equipped with N17P processors only (GTX 1050Ti/1050) Spare part number L14990-001 L14989-001 Before removing the USB board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 3. Disconnect all external devices from the computer. 4. Remove the following components: a. Base enclosure (see Base enclosure on page 45) b. Battery (see Battery on page 38) c. Optical drive (see Optical drive on page 48) d. Speakers (see Speakers on page 47) Remove the USB board: 1. Open the zero insertion force (ZIF) connector (1) and release the USB board cable. 2. Remove the two Phillips M2.0 × 4.0 screws (2) that secure the USB board to the computer. 3. Remove the USB board (3). Reverse this procedure to install the USB board. 52 Chapter 6 Removal and replacement procedures for authorized service provider parts
![](/manual_guide/products/hewlettpackard-omen-17an000-maintenance-service-guide-d2f094f/64.png)