HP Pavilion 11-h013dx HP Pavilion 11 x2 PC Maintenance and Service Guide - Page 42

Remove the wireless antenna, Detach the wireless antenna transceivers

Get HP Pavilion 11-h013dx PDF manuals and user guides View all HP Pavilion 11-h013dx manuals
Add to My Manuals
Save this manual to your list of manuals

Page 42 highlights

Remove the wireless antenna: 1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module. NOTE: The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled "1". The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2". 2. Release the wireless antenna cables from the routing clips (2) built into the display panel assembly. 3. Detach the wireless antenna transceivers (3) from the heat sink. (The wireless antenna transceiver is attached to the heat sink with double-sided tape.) 4. Remove the wireless antenna cables and transceivers. Reverse this procedure to install the wireless antenna cables and transceivers. 34 Chapter 5 Removal and replacement procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
Remove the wireless antenna:
1.
Disconnect the WLAN antenna cables
(1)
from the terminals on the WLAN module.
NOTE:
The WLAN antenna cable labeled “1” connects to the WLAN module “Main” terminal
labeled “1”. The WLAN antenna cable labeled “2” connects to the WLAN module “Aux” terminal
labeled “2”.
2.
Release the wireless antenna cables from the routing clips
(2)
built into the display
panel assembly.
3.
Detach the wireless antenna transceivers
(3)
from the heat sink. (The wireless antenna transceiver
is attached to the heat sink with double-sided tape.)
4.
Remove the wireless antenna cables and transceivers.
Reverse this procedure to install the wireless antenna cables and transceivers.
34
Chapter 5
Removal and replacement procedures