HP Pavilion dv6-2100 HP Pavilion dv6 Entertainment PC - Maintenance and Servic - Page 77
of the system board until it rests at approximately a 45-degree angle., Lift up on the right side
View all HP Pavilion dv6-2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Removal and replacement procedures Remove the system board: 1. Disconnect the following cables from the system board: 1 Modem module cable 2 Audio/infrared board cable ✎ The audio/infrared board cable connects to a LIF connector on the system board. 3 USB board cable ✎ The USB board cable connects to a LIF connector on the system board. 4 Power connector cable 2. Remove the Phillips PM2.5×7.0 screw 1 that secures the system board to the base enclosure. 3. Lift up on the right side 2 of the system board until it rests at approximately a 45-degree angle. 4. Lift the system board to the right and up and out of the base enclosure 3. Reverse this procedure to install the system board. 4-38 Maintenance and Service Guide
4–38
Maintenance and Service Guide
Removal and replacement procedures
Remove the system board:
1. Disconnect the following cables from the system board:
1
Modem module cable
2
Audio/infrared board cable
✎
The audio/infrared board cable connects to a LIF connector on the system board.
3
USB board cable
✎
The USB board cable connects to a LIF connector on the system board.
4
Power connector cable
2. Remove the Phillips PM2.5×7.0 screw
1
that secures the system board to the base enclosure.
3. Lift up on the right side
2
of the system board until it rests at approximately a 45-degree angle.
4. Lift the system board to the right and up and out of the base enclosure
3
.
Reverse this procedure to install the system board.