HP Pro 3400 HP Pro 3400 Microtower PC, HP Pro 3405 Microtower PC, HP Pro 3410 - Page 80
Fan Sink Assembly, CAUTION
View all HP Pro 3400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Fan Sink Assembly Description Fan sink for use in models with Intel processors Fan sink for use in models with AMD processors Spare part number 667727-001 657402-001 1. Prepare the computer for disassembly (Preparation for Disassembly on page 42). 2. Remove the access panel (Access Panel on page 43). 3. Disconnect the fan sink cable from the white system board connector labeled CPU FAN (HP Pro 3400/3405) or CPU_FAN1 (HP Pro 3410) (1). 4. Loosen the four captive Torx screws (2) that secure the fan sink to the system board. 5. Lift the heat sink from the processor (3) and set it on its side to keep from contaminating the work area with thermal grease. Figure 7-25 Removing the fan sink CAUTION: Heat sink retaining screws should be tightened in diagonally opposite pairs (as in an X) to evenly seat the heat sink to the processor. This is especially important as the pins on the socket are very fragile and any damage to them may require replacing the system board. When reinstalling an existing heat sink, make sure that its bottom has been cleaned with an alcohol wipe and fresh thermal grease has been applied to the top of the processor. New heat sinks come from the factory with fresh thermal grease already applied. 70 Chapter 7 Removal and Replacement Procedures - Microtower Chassis