HP ProDesk 600 G5 Maintenance and Service Guide - Page 48
Fan shroud, Disconnect the power supply P3
View all HP ProDesk 600 G5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Fan shroud Follow these steps to remove the fan shroud: 1. Prepare the computer for disassembly (see Preparation for disassembly on page 30). 2. Remove the access panel (see Access panel on page 31). 3. Remove the front bezel (see Front bezel on page 33). 4. Remove the drive cage (see Drive cage on page 36). Remove the fan shroud: 1. Position the computer with the rear panel toward you. 2. Disconnect the power supply P3 (1) cable from the system board. 3. Release the power supply P3 cable from the retention clips built into the fan shroud (2). 4. Press out on the fan shroud release tabs (3). 5. Remove the fan shroud (4). Reverse this procedure to install the fan shroud. 40 Chapter 4 Removal and replacement procedures
Fan shroud
Follow these steps to remove the fan shroud:
1.
Prepare the computer for disassembly (see
Preparation for disassembly
on page
30
).
2.
Remove the access panel (see
Access panel
on page
31
).
3.
Remove the front bezel (see
Front bezel
on page
33
).
4.
Remove the drive cage (see
Drive cage
on page
36
).
Remove the fan shroud:
1.
Position the computer with the rear panel toward you.
2.
Disconnect the power supply P3
(1)
cable from the system board.
3.
Release the power supply P3 cable from the retention clips built into the fan shroud
(2)
.
4.
Press out on the fan shroud release tabs
(3)
.
5.
Remove the fan shroud
(4)
.
Reverse this procedure to install the fan shroud.
40
Chapter 4
Removal and replacement procedures