HP ProLiant 6400R Compaq ProLiant 6400R Servers - Page 23
Power On/Standby Switch
View all HP ProLiant 6400R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
2-6 Compaq ProLiant 6400R Maintenance and Service Guide Power On/Standby Switch To remove the Power On/Standby switch and cable assembly, 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the top access panel. See "Top Access Panel" earlier in this chapter. 3. Disconnect the power switch cables from the power switch. 4. Disconnect the clips connected to each of the LEDs. IMPORTANT: Label each wire before disconnection from the LED terminals. Figure 2-2. Disconnecting the Power On/Standby switch 5. Using a 4-mm flat-blade screwdriver, press in the tabs on each side of the switch , and then pull the switch out the front of the bezel .
2-6
Compaq ProLiant 6400R Maintenance and Service Guide
Power On/Standby Switch
To remove the Power On/Standby switch and cable assembly,
1.
Perform the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2.
Remove the top access panel. See “Top Access Panel” earlier in this chapter.
3.
Disconnect the power switch cables from the power switch.
4.
Disconnect the clips connected to each of the LEDs.
IMPORTANT:
Label each wire before disconnection from the LED terminals.
Figure 2-2.
Disconnecting the Power On/Standby switch
5.
Using a 4-mm flat-blade screwdriver, press in the tabs on each side of the switch
, and
then pull the switch out the front of the bezel
.