HP ProLiant 6400R Compaq ProLiant 6400R Servers - Page 62
AC Power Cord and Plug Assembly
View all HP ProLiant 6400R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Removal and Replacement Procedures 2-45 7. Remove the side access panel. See "Side Access Panel" earlier in this chapter. 8. Loosen the three thumbscrews securing the system board and tray to the chassis . 9. Pull the system board and tray approximately ½ inch toward the front of the chassis, and slide it out through the side access panel . 1 2 Figure 2-43. Removing the system board and tray Reverse steps 1 through 9 to replace the system board and tray. AC Power Cord and Plug Assembly To remove the AC power cord and plug assembly, 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove all hot-plug power supplies. See "Hot-Plug Power Supply" earlier in this chapter. 3. Remove I/O fans 1 and 2. See "I/O Hot-Plug Fans" earlier in this chapter.