HP ProLiant 6400R Compaq ProLiant 6400R Servers - Page 72
Utilities Access
View all HP ProLiant 6400R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Diagnostics and Troubleshooting 3-5 Utilities Access The Compaq SmartStart and Support Software CD contains the SmartStart program and many of the Compaq utilities needed to maintain the system, including System Configuration Utility Array Configuration Utility Array Diagnostic Utility ROMPaq Firmware Upgrade Utilities Compaq Diagnostics CAUTION: Do not select the Erase Utility when running the SmartStart and Support Software CD. This will result in data loss to the entire system. Running Compaq Utilities There are three ways from which to access Compaq Utilities: System partition Diskette Compaq SmartStart and Support Software CD Running the Utilities from the System Partition If the system was installed using SmartStart, the Compaq utilities will automatically be available on the system partition. The system partition could also have been created during a manual system installation. To run the utilities on the system partition, start the system and press F10 when you see Press F10 for system partition utilities. Then select the desired utility from the menu The System Configuration Utility is available under the System Configuration menu. The Array Configuration Utility is available under the System Configuration menu. Compaq Diagnostics (Test and Inspect) are available under the Diagnostics and Utilities menu. The ROMPaq Firmware Upgrade Utility is available under the Diagnostics and Utilities menu. Running the Utilities from Diskette Run the utilities from their individual diskettes. If you have a utility diskette newer than the version on the SmartStart and Support Software CD, use that diskette. Create a diskette version of the utility from the SmartStart and Support Software CD.