HP ProLiant 6400R Compaq ProLiant 6400R Servers - Page 82
SMART-2 Controller error. Data
View all HP ProLiant 6400R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Diagnostics and Troubleshooting 3-15 Table 3-2 POST Error Messages continued Error Code Audible Beeps 1774-Slot x Drive None Array - Obsolete data found in Array Accelerator. Select F1 to discard contents of Array Accelerator. Select F2 to write contents of Array Accelerator to drives. 1775-Slot x Drive None Array - ProLiant Storage System Not Responding SCSI Port (y): Check storage system power switch and cables. Turn the system power off while checking the ProLiant power and cable connections, then turn the system power back on to retry. 1776-Drive Array - None SCSI Port Termination Error 1777-Drive Array None External Drive Subsystem Error 1778-Drive Array None resuming Automatic Data Recovery process 1779-Drive Array None Controller detects replacement drives 1780-Disk 0 Failure None 1781-Disk 1 Failure None Probable Source of Problem SMART-2 Controller error. Data found in the array accelerator are older than data found on drives. Recommended Action Press F1 to discard the older data in the array accelerator and retain the newer data on the drives. Storage system error Turn off power to system. Check the external ProLiant power switch. External drives must all be powered up before or at the same time as the main system. Check the cables. If a retry does not help, replace the cable, ProLiant firmware, ProLiant backplane, or Smart Array Controller. External and internal SCSI drives Reconfigure drives. are both configured to port 1. Cooling fan failure, internal temperature alert, or open side panel A controller reset or power cycle occurred during automatic data recovery. Inspect for cooling fan failure or open side panel. No action necessary. Intermittent drive failure and/or possible loss of data Hard drive/format error Hard drive/format error If this message appears and drive X has not been replaced, an intermittent drive failure has occurred. This message also appears once immediately after drive replacement whenever data must be restored from the backup. Run Diagnostics. Replace the failed assembly as indicated. Run Diagnostics. Replace the failed assembly as indicated. continued